P10) 416 OFPPk (Setup & Installation)


SETUP

Pack Description:
Each pack comes with the following items:
  1. Positive and Negative Plates - 1 pair (Assembled)
  2. Guide Plate
  3. Positive (Red) and Negative (Green) Cover - 1 pair
  4. Long screws and nut -14 sets



INSTALLATION
    Preparation:
  1. 18650 battery - 64 pcs (by DIYer)
  2. Multimeter - 1 pc (by DIYer)
  3. M5 Allen Key - 1 pc (Supplied)
Prior to the installation, kindly check thru the Configuration Page on what power requirement you need.

Setup Instruction:
Remove all packing materials. 



Step 1) Place the negative plate [1] (w/Green Cover) on a flat platform or table with the cell holder facing up. 
Step 2) Place the guide plate [2] over the negative plate and align all the holes. (Optional)
Step 3) Place 64 batteries [3] thru the guide plates and onto the negative plate. Position the Battery (-) to Negative plate. (+) facing up.
Step 4) Move the guide plate [2] to the battery centre area. This is to allow easy alignment of the positive plate.
Step 5) Depend on the orientation you need (Refer to Built Arrangement), place the positive plate [4] over the positive side of the batteries. Align all the batteries to sit inside the round holes. Ensure all the nickel contact strip is in contact with the battery.
Step 6) Put all 14 long screws [5] and nuts [6] at the above locations. Using the supplied Allen key, tighten each screw gradually. Tighten in a diagonal direction. Do not over tighten. 
Step 7) Using multimeter, measure across the positive and negative side to check the voltage within ~ 3.7V-4.1V.
Step 8) Install back the insulated cover, and insert the provided clip.


Connecting to another pack. 
Step 1) Remove one of the Connecting Plate and link (place across) the next 416 OFPPk pack. Tighten all the screws.
Step 2) Once all the pack is link up, do a complete multimeter check to verify if the voltage is correct. (Refer to Configuration Page)
Step 3) You may connect to your own BMS, Disconnect switch, Inverter or Solar Controller after this installation is completed.

416 OFPPK Assembly video

Here's the link to the logo design template: 416 Template. Do register to get access... is free.
Here's some tutorial on the program itself: Canva

Congratulation, you have completed installing a 416 OFPPk Battery Pack.

Enjoy...

Comments